H&R 60mm I.D. Race Springs 160mm Length

H&R 60mm I.D. Race Springs 160mm Length

Price is per each spring, not for a pair of springs.

To get a pair, order a quantity of 2. Be sure to choose the correct Price Class so your order is not delayed to collect correct payment.

The H&R 60mm I.D. Race Spring line is crafted from special lightweight (hf) 54SiCr6 spring steel and is the most comprehensive 60mm I.D. Race Program in the U.S. If you own a Porsche GT3 or another Euro spec car, our range of 60mm I.D. Race Springs has you covered. With hundreds of main springs and tender springs available, H&R has the lengths and rates necessary for optimal tuning and setup.

The H&R complete line of 60mm main and tender springs includes main springs ranging from 100mm to 300mm (25.4mm = 1 inch) in length and 30 N to 700 N (N/mm x 5.709 = pounds/inch) spring rates. Tender springs vary in length from 40mm to 130mm, with many spring rates available.

TENDER SPRINGS

H&R 60mm I.D. Tender Springs are made of trapezoidal (flat rather than round) spring wire for a low block height and maximum travel. These springs are designed for demanding motorsport environments, and, like all H&R springs, have been pre-blocked at the factory so they will never set or sag. Also available are H&R inside and outside locating spring retainers. Tender springs vary in length from 40mm to 130mm, with many spring rates available. 

The Special I.D. Race Spring has  a Dual ID, Upper ID is 59.2mm and the Lower ID is 51.0mm